Pair: 2 - 12
Cross-Section: 0,22 mm2 - 1,5 mm2		 Cables | Halogen Free Flame Redundant cables

LIH(St)H-PIMF  HFFR SIGNAL AND CONTROL CABLE

Application

These screened control and connecting cables are used in instrumentation and control engineering; in industrial electronics, computers, information and transmission systems office machines; data transmission cables for voice frequncy transmission. Screen provides protection against external pulses. Also tinned copper drain wires for continuity of individual screen and for earthing. In case of fire, these cables inhibit the propagation of the flames whereby the development of smoke is extremely low. No corrosive gases are emitted in the event of fire.

Cable design Tehnical data
Conductor : Plain Cu wires, flexible, IEC 228-5.
Insulation : HFFR compound ; DIN 47100 or numbered cores
Pair : Two conductors twisted to a pair
PIMF Costruction : Wrapping of polyester tape , with Sncu drain wire (7 wires), AL-PES tape and polyester tape wrapping
Lay-up : PIMF Pairs laid up in layers of optimum pitch.
Separator : Polyester tape
Screen : With drain wire (7 wires) under the AL-PES bant.
Outer Sheath : HHFR compound
Sheath Colour : RAL 7001, Grey
Standard : VDE 0812, VDE 0815
Insulation resistance : > 100 Mohm.km
Mutual Capacitance(800 Hz) : 120 nF/km
Operating voltage : 300 V
Test voltage (AC 50 Hz) : 1200 V
Temperature range : -30 °C / +70 °C
Min. Bending radius : 15 x Cable diameter
Flame test : IEC 332-1 & IEC 332-3